Operating Instructions; Operating By Remote Control; Maintenance; Preparation For Maintenance - Napoleon EFL100 Instructions D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

12

5.0 OPERATING INSTRUCTIONS

EN
Once the appliance has been plugged in to a grounded electrical outlet, it is ready to operate.
NOTE: Ensure the house circuit breakers for the power supply are turned on. In the event of a power
failure, the fl ame will turn on indicating that the power has been restored.
5.1

OPERATING BY REMOTE CONTROL

NOTE: Make certain the batteries are installed correctly, for installation
instructions review "REMOTE BATTERY INSTALLATION" section.
A.
When operating the remote control, it must be directed towards the front
center of the appliance.
B.
The power button can be used to power up or down the appliance.
Pressing this button
C.
To turn off the appliance, press the power button once.
NOTE: This remote control must remain within 8 meters or 26 feet of the
appliance to be effective.

6.0 MAINTENANCE

ALWAYS DISCONNECT THE POWER AND ALLOW THE ELECTRIC APPLIANCE TO COOL BEFORE
PERFORMING ANY CLEANING, MAINTENANCE OR RELOCATION OF THIS ELECTRIC APPLIANCE.
TURN CONTROLS TO OFF AND REMOVE PLUG FROM OUTLET OR TURN OFF THE HOUSE
DO NOT INSTALL REPLACEMENT LAMPS THAT EXCEED SPECIFIED MAXIMUM WATTS.
THE HALOGEN LAMPS IN YOUR APPLIANCE CAN BECOME EXTREMELY HOT. ALLOW AT LEAST
10 MINUTES BETWEEN TURNING OFF THE APPLIANCE AND REMOVING THE LAMPS TO AVOID
DO NOT HANDLE THE LAMP WITH BARE FINGERS, OILS FROM YOUR SKIN WILL DAMAGE THE
LAMPS WHEY THEY HEAT UP. USE GLOVES OR A CLEAN DRY CLOTH WHEN HANDLING LAMPS.
6.1

REMOTE BATTERY INSTALLATION

1. To replace the existing battery remove the
battery holder.
2. To remove the battery holder turn remote onto
front side and press the left side leaver towards
the center while pulling the battery holder out
using the slot provided.
3. Replace existing battery, type CR 2025, with a
new battery and reinstall the battery holder into
the remote by sliding it into position, as shown.
4. Battery holder is secure into the remote control
when a "CLICKING" noise is heard.
W415-1140 / A / 07.04.13
activates the power to the appliance.

PREPARATION FOR MAINTENANCE

CIRCUIT BREAKER TO ELECTRIC APPLIANCE RECEPTACLE.
ACCIDENTAL BURNS.
WARNING
!
BATTERY (CR 2025)
BATTERY HOLDER
REMOTE
(REAR SIDE)

Publicité

Chapitres

Table des Matières
loading

Table des Matières