Steam Burst; Vertical Steam Ironing - Cleanmaxx CEA-YC698 Mode D'emploi

3. Insert the mains plug of the station in a properly installed socket that is easily ac-
cessible. Ensure that the mains cord (4) does not pose a tripping hazard. Keep the
station turned off.
4. Set the steam quantity control (7) on the station to the OFF position.
5. Depending on the care label of the material intended be ironed, set the temperature
controller (11) on the iron to the medium (••) up to the maximum temperature. Steam
ironing is possible in this area.
6. Place the iron in the station to heat it up.
7. Set the desired steam quantity using the steam quantity control (7).
8. Turn on the station by fl ipping the On/Off switch (5) to the 1 position.
9. During preheating, the control lights of the station and the iron will illuminate. Wait
until the temperature control lights (however not the lights of the On/Off switch!) go
out. The device is ready to use now and you can start ironing. You can change the
steam quantity as required.
10. If the water tank is empty, no more steam will be produced. Set the steam quantity
control to OFF, switch off the station/pull the mains plug and fi ll up the water tank as
described in section "Filling the water tank".

Steam burst

• To straighten stubborn creases push the steam burst button (13)
burst is generated thereupon.
Please note: The lower the set temperature, the lower will be the steam quantity
generated by the device.

Vertical steam ironing

ATTENTION!
❐ When ironing vertically, make sure that there is enough space around the piece of
clothing you intend to iron. Vertical ironing shall only be applied if the piece of clothing
is hanging on a coat hanger and cannot come in contact with other pieces of clothing,
objects, persons or animals.
❐ Observe the notes in the chapters "Ironing recommendations" and "Use"!
• Vertical steam ironing is suitable for hanging textiles (coats, suits, curtains) and for
removing creases.
• Only hang the laundry to be ironed in a place where there is no risk of heat and mois-
ture infl icting damage, e.g. NOT in front of wallpaper, windows or mirrors.
• Set the highest level using the temperature and steam
quantity control. Steam the material to be straightened.
However, do not touch it with the soleplate, if it is not
suitable for the maximum temperature (refer to chapter
"Ironing recommendations"). If required, push the steam
burst button (13)
22
.
. A strong steam