Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DMX Output
5-Pin XLR Socket
5
1
4
2
3
Adress 1
Adress 4
DMX-512 connection with DMX
terminator
For installations where the DMX cable has to run a long
distance or is in an electrically noisy environment, such as in
a discotheque, it is recommended to use a DMX terminator.
This helps in preventing corruption of the digital control signal
by electrical noise. The DMX terminator is simply an XLR plug
with a 120 Ohms resistor connected between pins 2 and 3,
which is then plugged into the output XLR socket of the last
fixture in the chain. Please see illustrations below.
4
5
Projector DMX starting address
selection
All fixtures should be given a DMX starting address when
using a DMX signal, so that the correct fixture responds to
the correct control signals. This digital starting address is the
channel number from which the fixture starts to "listen" to the
digital control information sent out from the DMX controller.
The allocation of this starting address is achieved by setting
the correct number on the display located on the base of the
device.
You can set the same starting address for all fixtures or a
group of fixtures, or make different address for each fixture
individually.
If you set the same address, all the units will start to "listen"
to the same control signal from the same channel number. In
other words, changing the settings of one channel will affect
all the fixtures simultaneously.
DMX Input
5-Pin XLR Socket
1. Ground
1
5
2. Signal (-)
3. Signal (+)
2
4
3
4. N.A.
5. N.A.
Adress 9
USER MANUAL
If you set a different address, each unit will start to "listen"
to the channel number you have set, based on the quantity
of control channels of the unit. That means changing the
settings of one channel will affect only the selected fixture.
In the case of the move head, which is a 4 channel fixture,
you should set the starting address of the first unit to 1, the
second unit to 5 (4 + 1), the third unit to 9 (4+ 5), and so on.
Control Board
Keys buttons functions:
LEFT Button :
escape or return to previous menu
MENU Button :
validate and save the choice, or enter
into sub-menu
RIGHT Button :
modify value when «>» is drawn
UP Button :
Displays the following menu / increments
a value
DOWN Button :
Displays the previous menu / decreases
a value
Flip screen :
> Press both
+
buttons
Or
> Press both
+
buttons
Activate menu:
Select trigger method to start AUTO mode. Act on the latest
CONFIG selection adjusted (Static or Dynamic).
Power ON:
AUTO mode will start each time the unit is powered ON.Dmx
input is not activate in this mode.
Run:
AUTO mode will run until the unit is powered OFF.
Dmx input is not activate in this mode.If the unti is powered
ON again, no AUTO mode will run.
Back up:
WIll switch to AUTO mode if there is no valid DMX inputon
the unit. If DMX input come back, AUTO mode will stop and
so on...
7
buttons, and then both
buttons, and then both
+
+
Publicité
Table des Matières
