PowerPeak HOME TRAINER Mode D'emploi page 30

Attention
Some of the above mentioned parts have already been assembled to a main part. These are not
delivered separately!
ASSEMBLY
In order to familiarise yourself with the parts of the device, we advise you to study the overview
picture and the parts list carefully before you start assembly. Place all the parts on the floor and
remove all packaging materials.
Use the present tooling for assembling. Before assembling please check whether all needed parts are
available (at the above of this instruction sheet you will find an explosion drawing with all single parts
(marked with numbers) which this item consists of.
Step 1: Assembling the front and rear stabilizer
Attach the Front Stabilizer(30) and the Rear
Stabilizer(1) to the Main Frame(2) with Carriage Bolt
(5), Domed Nut (9) and Arc Washer(8).
Step 2: Assembling the handle bar post and connecting the tension control and computer cable
Connect the Sensor Wire B1 and B2; Connect
Tension Control wire A1 and A2 as shown in FIG.2,
Fix the Upright Post (3) to the Main Frame (2) with
Bolt (11), Arc Washer (12).