Setting The Cutting Height; How To Cut Properly - Brill Luxus 33 Mode D'emploi

1.2. Assembling the guide handle
1. Tilt your Hand Lawnmower so
that the black rollers face
GB
upwards (Fig. B). Fit the lower
section of the guide handle
((Fig. A Pos. 1) so that the
drilled holes (Fig. C Pos. 6)
are over handle bolts (Fig. C
Pos. 7).

2. Setting the cutting height

Place the mower on a firm level
surface. Stand behind the mower
so that you can place one foot
on the rollers (Fig. D Pos. 9)
Loosen the two setting screws
(Fig. D Pos. 10). You can now
use both hands to set the cutting
height with the setting handles
(Fig. D Pos. 11).
Model Longest Shortest
cut
Luxus 33 45 mm
Comfort 30 40 mm
Make sure that the cutting height
marking arrows (Fig. E Pos. 12)
show the same height on the

3. How to cut properly

The hand mowers can cut grass
up to the following lengths:
Model Length in mm
Luxus 33 140
Comfort 30 120
If you want a well-looked after
lawn, the grass must always be
kept shorter.
At the beginning of the cutting
period, and with new lawns,
select a relatively high cutting
height and gradually reduce this
each time you mow the lawn.
10
Note:
Make sure that the groove in
the drilled hole (Fig. C Pos. 6)
and the locking tab of the
handle bolt (Fig. C Pos. 7)
meet.
Warning! Do not use
A
excessive force.
First ensure that the recess
scale on both sides. Now tighten
the setting screws (Fig. E Pos. 10).
The mower must be set so that
the bottom blade does not come
into contact with the ground
where there is any unevenness.
Attention! Never use the
A
mower near people,
especially children, or animals.
cut The user is responsible for all
injuries.
14 mm
Before using the mower, always
18 mm
check the nuts, bolts and
working tools for wear or
damage. Replace worn
or damaged blades in sets.
If you want to have a well-mani-
cured lawn, set the cutting height
to approx. 2 cm. Cut the grass
every week if possible. Frequent
cutting forces the growth into the
cut stalk and makes it resistant.
If possible, always cut the grass
when it is relatively dry. To obtain
a clear pattern, push the mower
in straight lines at an even walk-
ing pace. The cutting paths should
overlap by a few centimetres to
avoid leaving strips of grass.
Attention! Be careful!
A
The rotating blade roller
can cause injuries!
in the handle and the lug
of the bolt are in alignment
and then fix together.
2. Now attach the middle and
top sections of the guide
handle using the bolts and
wing nuts provided (Fig. A).
Always make sure you have
a clear view when using the
mower. When mowing, wear
proper shoes with non-slip
gripping soles and long trousers.
Before using the mower, check
the area you want to cut and
remove any stones, pieces of
wood, wire and similar objects.
The blades can catapult objects
like this at great speed.
If the blades or the mower hit
any solid object or obstruction,
have the mower examined by
an expert.
Always keep the safety distance
between the user and blade
roller shown by the push bar.
Take extra care when mowing
on embankments and slopes:
make sure you are on firm
ground and always wear shoes
with non-slip gripping soles and
long trousers. Always mow
across a slope.
Take special care when moving
backwards and when pulling
the mower. Danger of stumbling!
Never place your hands or feet
on or underneath moving parts.