Notes To The Instructions For Use; Correct Operation; Lawn Mower; Assembly - Brill Basic 32 E Mode D'emploi

1. Notes to the instructions for use

GB
Users are requested to read these
instructions for use carefully and
observe the contents as well as
the enclosed notes on safety pre-
cautions. In conjunction with the
instructions for use, users should
familiarise themselves with the
machine, its adjuster controls,
its correct operation as well as
with the safety precautions.

2. Correct operation

The

lawn mower

is designed for
the cutting of lawns and grass
spaces in private-house and hobby
gardens, and not for commercial
use in public spaces, parks, sports
grounds, along the streets and
in agriculture and forestry.
Compliance with the instructions
for use enclosed by Brill is a pre-

3. Assembly

3.1. Check of complete machine
assembly
The original packaging includes
the following parts:
Electric lawn mower
.
Grass collection hopper
.
Instructions for use with
.
warranty card
Index of service stations
.

4. Preparing the machine for use

4.1. Adjusting the height of the
handlebar frame
(only 40 E and 46 E)
Figure 1
The lawn mower is equipped
with height adjustable handlebar
frame, which can be individually
adjusted to the height of the body.
16
Children or other persons,
A
who are unfamiliar with
these instructions for use, should
never be permitted to operate
the lawn mower. Local authority
regulations may also require a
minimum age for users.
Never use the mower when
other persons, especially children
condition for the regular use of
the machine.
The instructions for use also in-
clude the operating, servicing
and maintenance conditions.
Caution ! Because of the
A
danger of bodily harm, the
machine may not be used to trim
3.2. Assembly of
the handlebar frame
Figure 1
Unfold the Z-shaped folded handle,
tighten the bar locking handle
Basic
(Fig. 1, Pos. 1).
Allow the handle to engage and
tighten well with the lower linkage
tightening handle (Fig. 1, Pos. 2).
To adjust the height, the joint-
tensioning grips (Fig. 1, Pos. 2)
should be slackened and the
handlebar allowed to engage
the latch at the required height.
The two joint-tensioning grips
should then again be tightened
(Fig. 1, Pos. 2).
or domestic animals are in the
vicinity.
You should be aware, that the user
of the mower or the owner is liable
in case of any accidents to other
persons or loss or damage to third
party property.
These instructions for use should
be kept in a safe location.
bushes, hedges and shrubs, nor
for the cutting and size-reduction
of creeper plants or lawns on
roof gardens or in balcony boxes.
The machine may also not be
used as a chopper for decimation
and breaking up of cuttings from
trees and hedges as well as for
the levelling of uneven ground.
Make sure that the lead runs out-
side the frame and is not crushed.
Fix the lead in place by pushing the
clamp from outside onto the lower
part of the frame (Fig. 1, Pos. 3).

4.2. Setting the cutting height

Figure 2
The cutting height can be altered
stagelessly and centrally with a
twist grip adjuster (Fig. 2, Pos. 1).
The height setting can be read off
via the digital display in 5 mm
divisions (Fig. 2, Pos. 2).