Brill 40 B Mode D'emploi page 27

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Malfunction
Abnormal noises, clattering in
the machine.
Unsteady running, strong
vibration of the machine.
Motor fails to start.
(Honda
GCV
Motor)
Motor fails to start.
(Briggs & Stratton Quantum Motor)
Motor fails to start.
Motor fires and commences
running for a short time.
Then it suddenly stops with a
loud explosion.
The grass is tawny.
Irregular cut.
Whistling noise.
Wheel tractor drive fails to
function
(except 40 B and 40 B OHC).
Possible Cause
Loose screws on the motor, its
fixing pieces or the mower housing.
Damage to the cutter bar or cutter
(unbalanced running), cutter bar
holder on the motor drive shaft
loose.
Accelerator lever is not in the
CHOKE position.
Accelerator lever is not in the
START position.
Sparking plug defective or fuel
tank empty.
The cylinder, piston and bearing
of the crankshaft have seized up.
No motor oil in the crankcase.
Cutter too blunt.
Cutting height set too low.
Slipping drive belt.
Drive belt broken.
Clutch cable stretched.
Remedy
Tighten all screws.
Tighten the cutter and cutter bar
fixture screws.
Have damaged parts replaced by
the Brill service station.
The accelerator lever should be
set to the CHOKE position (see
section
4, Preparing the machine
for use).
The accelerator lever should be
set to the START position (see
section
4, Preparing the machine
for use).
Clean the sparking plug and/or
fill fuel tank respectively.
Workshop overhaul of the motor
necessary by the authorised
specialist dealer.
Change and/or turn cutter,
respectively. Set the cutting height
a little higher.
Obtain assistance from a Brill
Service Station.
The drive belt is to be replaced.
Obtain assistance from a Brill
Service Station.
Readjust the clutch cable
(see section 6, Maintenance of
the wheel tractor drive).
GB
25

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

40 b ohc40 br40 br v1246 br46 br v1246br ohc

Table des Matières