Removing The Front Wheel - Husqvarna TE 310 2010 Guide D'utilisation Et D'entretien

REMOVING THE FRONT WHEEL

Set a stand or a block under the engine and see that the front
wheel is lifted from the ground. Loosen the bolts (1) holding
the wheel axle (2) to the front
fork stanchions.
SMR: remove the two screws (A) and the brake caliper.
Hold the head of the wheel axle (2) in place, unscrew the bolt
(3) on the opposite side; draw the wheel axle out.
SMR
52
NOTES
Do not operate the front brake lever when the wheel has been
removed; this causes the caliper piston to move outwards. After
removal, lay down the wheel with brake disc on top.
TE-TC-TXC
2
TE-TC-TXC
1
A
2
1
1
3
1
SMR
3
SMR