Husqvarna TE 310 2010 Guide D'utilisation Et D'entretien page 136

The standard calibrations and the adjustment procedures are
shown below.
ADJUSTING THE COMPRESSION FORK
(TE 310/EU - SMR 450, 510)
a) Compression (Lower register)
Standard calibration: -12 clicks .
Remove plug (B) and turn register (A) clockwise until the posi-
tion of fully closed is reached then, turn back by the men-
tioned clicks.To obtain a smoother braking action, turn the reg-
ister anticlockwise. Reverse the operation in order to obtain a
harder action.
a)
A
B
b)
C
42
b) EXTENSION (upper register)
Standard calibration: - 12 clicks.
To reset standard calibration turn register (C) clockwise to
reach the position of fully closed; then, turn back by the men-
tioned clicks. To obtain a smoother braking action, turn the
register anticlockwise. Reverse the operation in order to obtain
a harder action.
TE-SMR
c) AIR VENT (to carry out after each competition, or monthly).
Set the motorcycle on a central stand and release the fork fully
and loosen the air vent valve (D). Once this operation is over,
tighten the valve.
WARNING: Never force the adjusting screws
beyond the maximum opening and closure
positions.
TE-SMR
C
D