Husqvarna TE 310 2010 Guide D'utilisation Et D'entretien page 150

BRAKE PADS REMOVAL
- Remove springs (1).
- Remove pins (2).
- Remove pads.
CAUTION!
Don't operate the brake lever or pedal
while removing the pads.
TE-TC-TXC
1
56
PADS WEAR (TE-TC-TXC)
Inspect pads for wear.
Service limit " A" is: 3,8 mm (0.15 in.).
If service limit is exceeded, always replace the pads in pairs.
SMR
FRONT
1
FRONT
2
2
2
1
REAR
PADS WEAR (SMR)
a) In front: thickness "A" must never be lower than the one
pointed out by the wear control notches.
b) At the back: thickness "A" must never be lower than 3,8
mm.
If service limit is exceeded, always replace the pads in pairs.
TE-TC-TXC