Husqvarna TE 310 2010 Guide D'utilisation Et D'entretien page 124

REPLACEMENT OF COOLING FLUID
Place a vessel on the R.H. side of the cylinder, under the
coolant drain screw (1).
FIRST remove the screw (1) then SLOWLY open the R.H. radia-
tor cap; slope the motorcycle on the right side to drain the
coolant easily in the vessel. Reassemble the screw (1).
Pour the necessary quantity of coolant in the radiator then
warm up the engine in order to eliminate any possible air bub-
ble.
1
30
Periodically check the connecting hoses (see "Periodical main-
tenance card"): this will avoid coolant leakages and conse-
quent engine seizure: If hoses (A) show cracks, swelling or
hardenings due to sheats desiccation, their replacement shall
be advisable.
Check the correct tightening of the clamps (B).
A
B
B
A