Maintenance, Service, And Storage; Storage And Transport - 3M DBI-SALA Manual D'instructions

6.0 MAINTENANCE, SERVICE, and STORAGE

6.1 CLEANING: Cleaning procedures for the Self-Retracting Device are as follows:
• Periodically clean the exterior of the SRL using water and a mild soap solution. Position the SRD so excess water can
drain out. Clean labels as required.
• Clean lifeline with water and mild soap solution. Rinse and thoroughly air dry. Do not force dry with heat. An
excessive buildup of dirt, paint, etc. may prevent the lifeline from fully retracting back into the housing causing a
potential free fall hazard. Replace lifeline if excessive buildup is present.
6.2 SERVICE: Additional maintenance and servicing procedures must be completed by an authorized service center. Do not
attempt to disassemble the SRL or lubricate any parts.
6.3 STORAGE AND TRANSPORT: Store and transport Self-Retracting Device in a cool, dry, clean environment out of direct
sunlight. Avoid areas where chemical vapors may exist. Thoroughly inspect the SRL after any period of extended storage.
7.0 Labels
Figure 17 illustrates labels on the the Smart Lock Self-Retracting Devices and their locations. All labels must be present on the
SRD. Labels must be replaced if they are not fully legible. Pictograms on the labels are defined as follows:
1 Read Use Instructions located under the Lifeline Bumper
2 Do not load SRD Casing over an edge.
3 1 Person Capacity (See other side of label for weight range)
4 SRL - Not Leading Edge - Do not use over an edge.
5 SRL-LE - Leading Edge - Can be used over an edge.
14