FujiFilm instax SHARE SP-2 Mode D'emploi page 19

Printed pictures
Problems
Part or whole finished
print is white.
The picture is blurred.
A black line is printed
on the bottom of the
finished print.
instax_BO-B_6lang.indb 19
Possible Causes
● The back cover was opened before
you have used up the film.
1 Pressure was applied to the picture
immediately after it came out from
the printer.
2 The picture did not come out
smoothly.
● The printer shakes or has been
dropped and the film has become
misaligned.
Solutions
● Do not open the back cover until you have used
up the film; otherwise, the rest of the film may be
exposed and ruined for use.
1 Do not shake, bend, fold, or press the print.
2 Do not cover the film exit.
● Retransmit the image. If this does not solve the
problem, load a new film pack.
EN
19
4/13/2016 10:33:40 AM