FujiFilm instax SHARE SP-2 Mode D'emploi page 10

Connecting and Printing (Continued)
⁄
EN
@
INSTAX-1111
10
instax_BO-B_6lang.indb 10
Tap "Connect and print".
Before tapping "Connect
and print", tapping on
the upper right displays
the edit menu. You can add
a template or adjust an
image on this menu.
Tap "Done" to exit from the
menu.
When a printer is detected,
tap "Connect". If multiple
printers are detected, select
the printer to connect from
the list.
Printer's identifier (SSID) is
located on the bottom of the
printer.
¤ Enter the factory default
password (1111) or the one you
specified, then tap "OK".
The printer starts printing.
When printing, stabilize the
1111
printer by putting it on a
steady place such as a desk.
To reset the password to the factory default
(1111), turn the printer on while holding the
REPRINT button.
#
When the film has been ejected (the
printer stops making a sound), grasp
the edge of the film, then take it out.
1 film remaining LED turns off every
time you print an image.
4/13/2016 10:33:39 AM