Trouble Shooting; Possible Causes - FujiFilm instax SHARE SP-2 Mode D'emploi

TROUBLE SHOOTING

During printing
EN Problems
The printer cannot be
turned on.
You entered the
password, but the device
cannot be connected to
the printer.
You pressed the
REPRINT button, but
you cannot print.
16
instax_BO-B_6lang.indb 16

Possible Causes

1 The battery power is low. (The
battery remaining LED is flashing
red.)
2 The battery is not inserted correctly.
3 You did not press the POWER
button for long enough.
● The password is incorrect.
1 No images are stored in the printer.
(The film remaining LED flashes for
3 seconds.)
2 No film remains in the printer. (All the
film remaining LED are flashing.)
3 The film pack is not loaded. (All the
film remaining LED are flashing.)
Solutions
1 Charge the battery fully.
2 Insert the battery correctly.
3 Press and hold the POWER button for approx. 1
second.
● Turn the printer on while holding the REPRINT
button to reset the password to the factory
default (1111).
1 Transmit an image to print.
2 Load a new film pack.
3 Load a new film pack.
4/13/2016 10:33:40 AM