Battery Life - FujiFilm instax SHARE SP-2 Mode D'emploi

When you are cleaning the printer or you do not plan to use the printer for an extended period, remove the
battery. Failure to do so can cause a fire or electric shock.
Required
EN
If a problem arises, turn the printer off and remove the battery. Continued use of the printer when it
is emitting smoke, is emitting any unusual odor, or is in any other abnormal state can cause a fire or
Required
electric shock. Contact your FUJIFILM dealer.
The Battery
The following describes the proper use of batteries and how to prolong their life. Incorrect use can shorten battery life or
cause leakage, overheating, fire, or explosion.
The battery is not charged at shipment. Charge the battery completely before use.
■ Notes on the Battery
The battery gradually loses its charge when not in use. Charge the battery one or two days before use.
Battery life can be extended by turning the printer off when not in use.
Battery capacity decreases at low temperatures; a depleted battery may not function at when cold. Keep a fully charged
spare battery in a warm place and exchange as necessary, or keep the battery in warm place and insert it in the printer only
when shooting. Do not place the battery in direct contact with hand warmers or other heating devices.
■ Charging the Battery
Charge the battery using the supplied USB cable. Charging times will increase at ambient temperatures below +10 °C (+50 °F)
or above +35 °C (+95 °F). Do not attempt to charge the battery at temperatures above 40 °C (+104 °F); at temperatures below
+5 °C (+41 °F), the battery will not charge.
Do not attempt to recharge a fully charged battery. The battery does not however need to be fully discharged before
charging.
The battery may be warm to the touch immediately after charging or use. This is normal.

■ Battery Life

At normal temperatures, the battery can be recharged about 300 times. A noticeable decrease in the length of time the battery
will hold a charge indicates that it has reached the end of its service life and should be replaced.
28
instax_BO-B_6lang.indb 28
CAUTION
4/13/2016 10:33:42 AM