General Description - GYS BATIUM 7/12 Manuel D'utilisation

Translation of the original instructions

GENERAL DESCRIPTION

The Batium range is designed to charge all common batteries including lead-acid , electrolyte or gel batteries.
Reference
Voltage
Battery capacity
CONNECTIONS AND GENERAL OPERATIONS
Ensure that the correct sequences are followed.
Precaution: Check the electrolyte level for open batteries. Fill it up if necessary, before starting the charge.
1. Connect the clamps : Red clamp to the battery's (+) and black clamp to the battery's (-).
2. Connect the charger to the mains on a 230 V socket. An indicator
matches the latest saved data.
3. Select the battery voltage (6, 12, 24 V) according to the recommendations features on the
battery or according to the battery coupling (series or parallel cf p.5).
4. Select the battery capacity. The Batium automatically determines the charging current.
5. The charge starts automatically. The display indicates the battery's state of charge. (indicators
Step 1 :
Voltage rises
Step 2 :
Voltage regulation (duration : 2h).
Step 3 :
Charge ends (Floating charge).
In the event of a power cut, the BATIUM saves the state of charge (except in « SOS Recovery » mode), and resumes the
charge using the latest settings.
6. When the battery is charged, disconnect the power supply
7. Disconnect the clamps or the battery connectors.
FORCED CHARGE
If the battery is deeply discharged (very low voltage <2 V), the charge doesnt not start automatically. The charge indicator
not switch on. The battery voltage indicators
the charging current, then press the battery voltage button
on once the buttton is released. If no indicator switches on, your battery cannot be recovered (<0.5 V (± 0.3)).
« SOS RECOVERY » (BATIUM 15/12 AND 15/24)
When connecting the battery, the SOS Recovery indicator
long period, with a start in sulfation.
The « SOS Recovery » mode uses a specific curve to repair the battery over a 24 to 48 hours cycle.
To activate this feature, follow these steps :
1. Disconnect the battery from the vehicle. (OVERVOLTAGE DANGER)
2. Connect the Batium to the battery.
3. Connect the Batium to the mains.
4. Choose the charging voltage.
5. Activate « Sos Recovery » by pressing the button
off).
1
6. The indicator switches on and blinks when the "Sos Recovery" stops and the normal charge resumes.
7. The green indicator
12
BATIUM 7/12 • 7/24 • 15/12 • 15/24
7 / 12
6 V 12 V
From 15 Ah to 130 Ah
Risk of explosion or acid projections if the wrong voltage is selec-
ted (24V for a 12V battery).
A
, and capacity indicator
4
2
indicated the charge is over.
7 / 24
6 V 12 V 24 V
A
Voyant allumé
B
are switched on. In this situation, select the voltage and
3
during 5 seconds to start a "forced charge". The indicator
6
flashes to signal that the battery suffered a deep discharge over a
during 5 seconds, until the indicator
15 / 12 15 / 24
6 V 12 V 6 V
From 35 Ah to 225 Ah
(interface diagram p.5) and
To confirm the selection,
do not press any button
1
État
Permanent
Flashing
Green
6
switches on (the indicators
EN
12 V 24 V
B
switches on that
for 5 seconds.
2
and )
1
does
1
switches
B
are switched