Whirlpool ACM 795/LX/01 Mode D'emploi page 17

31902085.book Page 17 Thursday, September 22, 2011 2:39 PM
Activation and adjusting cooking zones
After switching on the hob, position the pot on the chosen cooking zone.
Activate the cooking zone by pressing the corresponding circular key: the number is displayed inside the circle, indicating the intermediate power level.
The hob automatically switches off if no function is selected within 10 seconds of switching on. If you are using a pot that is not suitable, not correctly
positioned or not of the correct dimensions for your induction hob, the message "no pot" will appear in the display (see figure on the left). If no pot is
detected within 60 seconds, the hob switches off.
To change the power level, slide your finger horizontally on the slide touchscreen: the number inside the circle increases/decreases as your finger slides up/down the
touchscreen, ranging from a min. setting of 1 to a max. of 9. The slide touchscreen can be used to activate the booster function by pressing "BOOST" ("P" on the display)
The "BOOST" power level can be used for 10 minutes maximum, after which the appliance automatically sets the power to level 9.
If more than one cooking zone is on, the slide touchscreen allows you to change the power level of the selected zone, indicated by the presence of a
luminous dot at the bottom right of the power level indicator. To select a zone, simply press the relative round key.
Deactivation of cooking zones
Select the cooking zone to be switched off by pressing the relative round key (a dot lights up at the bottom right of the power level indicator). Press OFF on the slide
touchscreen.
The cooking zone switches off and, if the zone is still hot, the letter "H" appears in the circle.
"H" is the residual heat indicator. The hob has such an indicator for each cooking zone; it signals which zones are still hot. When the cooking zone cools
down, the display goes off.
Timer selection
The timer can be used to set a max. cooking time of 90 minutes.
Select the cooking zone to be used with the timer (a dot lights up at the bottom right of the power level indicator), then set the required cooking time using the + and
- keys of the timer function: the time is minutes is shown next to the cooking zone display.
A few seconds after the key is pressed, the timer begins the countdown (the luminous dot of the selected cooking zone starts flashing).
Once the set time has elapsed, an acoustic signal sounds and the cooking zone switches off automatically.
Control panel lock
This function locks the hob controls to prevent accidental switching on (e.g. during cleaning operations).
Press the button for three seconds: a beep sounds and an indicator lights up above the padlock symbol to signal activation. The control panel is locked except for
the deactivation function. To deactivate the control lock, repeat the activation procedure. The luminous dot goes off and the hob is active again.
IMPORTANT: The presence of water, liquid spilled from pots or any kind of objects resting on the button under the symbol can accidentally activate or deactivate the
control panel lock function.
Hold
This function allows you to temporarily hold and then resume cooking processes maintaining previous settings (except for timer setting). Press the key
on the display in place of the power levels. To resume cooking, press the
Description of automatic functions
The hob features automatic functions for each cooking zone. The symbols of the available functions are shown next to the selection key of each cooking
zone. Every time an automatic function is selected, an indicator light turns on next to the symbol and the letter "A" appears in the cooking zone display.
Sensor Function
The SENSOR function automatically selects the ideal power level to bring water to the boil and signals boiling point.
After positioning the pot of water, switch on the hob and select the desired cooking zone. Press the key
on. During heating, an animation is displayed in the space next to the cooking zone.
Cooking zone selection and selected cooking zone/power level display
Indicates that one of the automatic functions is On
Cooking zone timer
Slide touchscreen (power adjustment)
key again .
GB17
: "A" appears on the display and the indicator light turns
: flashes