Recommended Separation Distances - EMS AIRFLOW Prophylaxis Master Mode D'emploi

Notes:
- UT is the a. c. mains voltage prior to application of the test level.
- At 80 MHz and 800 MHz, the higher frequency range applies.
- These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from
structures, objects and people.
Proximity fields from RF wireless communications equipment Proximity fields from RF wireless communications equipment Proximity fields from RF wireless communications equipment Proximity fields from RF wireless communications equipment
IEC 61000-4-3
Test Test Test Test Band Band Band Band
Frequency Frequency Frequency Frequency
(MHz) (MHz)
385 380-390
450 430-470
710
745 704-787
780
810
800-960
870
930
1720
1845
1700-1990
1970
2450 2400 -2570
5240
5500 5100 – 5800
5785

Recommended separation distances

The product is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The customer or the user of the
product can help prevent electromagnetic interference by maintaining a minimum distance between portable and mobile RF communications equipment
(transmitters) and the product as recommended below, according to the maximum output power of the communications equipment.
Rated maximum Rated maximum Rated maximum Rated maximum
output power of output power of output power of output power of
transmitter W transmitter
transmitter transmitter
0.01
0.1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in metres (m) can be estimated using the
equation applicable to the frequency of the transmitter, where P is the maximum output power rating of the transmitter in watts (W) according to the
transmitter manufacturer.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception
which can be determined by turning the equipment off and on, the user is encouraged to try to correct interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
ENGLISH
Service Service Service Service
TETRA 400
GMRS 460,
FRS 460
LTE Band 13, 17
GSM 800/900,
TETRA 800,
iDEN 820, CDMA
850, LTE Band 5
GSM 1800, CDMA
1900,
GSM 1900, DECT,
LTE Band 1, 3, 4,
25, UMTS
Bluetooth, WLAN,
802.11b/g/n, RFID
2450,
LTE Band 7
WLAN 802.11a/n
Separation distance according to frequency of transmitter (m) Separation distance according to frequency of transmitter Separation distance according to frequency of transmitter Separation distance according to frequency of transmitter
150 kHz to 80 MHz 150 kHz to 80 MHz 150 kHz to 80 MHz 150 kHz to 80 MHz
.
d = √P with V=3V
0.12
0.37
1.17
3.69
11.67
FB-618/EN – Rev. A-01 - 2017.03.30
Modulation Modulation Modulation Modulation Maximum power Maximum power Maximum power Maximum power
(W)
Pulse Modulation
1,8
18Hz
FM
±5 kHz deviation 2
1 kHz sine
Pulse
Modulation 0,2
217 Hz
Pulse
Modulation 2
18 Hz
Pulse
Modulation 2
217 Hz
Pulse
Modulation 2
217 Hz
Pulse
Modulation 0,2
217 Hz
80 MHz to 800 MHz 80 MHz to 800 MHz 80 MHz to 800 MHz 80 MHz to 800 MHz
.
d = √P with E=3V/m
0.12
0.37
1.17
3.69
11.67
Distance Distance Distance Distance Immunity Immunity Immunity Immunity
test level test level test level test level
(m) (V/m)
0,3 27
0,3 28
0,3 9
0,3 28
0,3 28
0,3 28
0,3 9
(m) (m) (m)
800 MHz to 2,5 GHz 800 MHz to 2,5 GHz
800 MHz to 2,5 GHz 800 MHz to 2,5 GHz
d = √P with E=3V/m
0.24
0.74
2.34
7.4
23.4
44/46