Trimming Outboard Motor - Yamaha F115 Manuel De L'utilisateur

ON
OFF
ON
OFF
ON ON
OFF OFF
2. After stopping the engine, disconnect
the fuel line if there is a fuel joint on the
outboard motor.
3. Tighten the air vent screw on the fuel
tank cap (if equipped).
4. Remove the key if the boat will be left un-
attended.
TIP:
ZMU01779
The engine can also be stopped by pulling
the cord and removing the clip from the en-
gine shut-off switch, then turning the main
switch to "
EMU27865

Trimming outboard motor

EWM00741
WARNING
Excessive trim for the operating condi-
tions (either trim up or trim down) can cau-
se boat instability and can make steering
ZMU06932
the boat more difficult. This increases the
possibility of an accident. If the boat be-
gins to feel unstable or is hard to steer,
slow down and/or readjust the trim angle.
The trim angle of the outboard motor helps
determine the position of the bow of the boat
in the water. Correct trim angle will help im-
prove performance and fuel economy while
reducing strain on the engine. Correct trim
ZMU05833
angle depends upon the combination of
Operation
" (off).
69