Reading Measurement Results, Remote Control; Description; Usb Cables; External Trigger - Hameg Instruments HM5530 Manuel

34
INPUT 50 Ω
29
Input N connector. Without attenuation (ATT 0 dB) +10 dBm and ±10 V
must not be exceeded. With an attenuation of 10 to 50 dB, the maximum
level is +20 dBm. Levels or dc voltages above the values mentioned
may destruct the input stage. The outer contact is connected to the
instrument chassis and thus to safety ground (PE).
30

External TRIGGER

External trigger input BNC connector.
Low-Pegel: 0 ... +0.8 V, High-Pegel: +2.5 V ... + 5.0 V
pos. edge triggered, Treshold typ.: 1.3 V,
max. Input voltage: ±10 V
31
ON
Pushbutton for activating the external trigger.
32
TEST SIGNAL ON
Pushbutton for turning the test signal on/off.
OUPUT 50 Ω
33
Test signal output N connector. If the ON pushbutton
test signal with a broad spectrum is available the level of which can be
adjusted from –10 to 0 dBm with the tuning knob
28
TEST SIGNAL LEVEL . The test signal level is indicated in the readout
fi eld (TL ... dBm). The output may be connected directly with the input
with a N cable in order to test the function of the instrument. The outer
contact is connected to the chassis and hence to safety ground (PE).
34
PROBE POWER
2.5 mm jack, power supply (6 V , max. 100 mA) for HAMEG fi eld probes.
DC
The outer contact is connected to the chassis and hence to safety ground
(PE), the inner conductor is the positive terminal.
I n t e r f a c e , R e a d i n g m e a s u r e m e n t r e s u l t s , r e m o t e c o n t r o l
26
DC
31
is lit, a 50 MHz
7
after depressing
1 2 3 5
4
28 25 21
27 24 20
33 23 32 19 22
RS-232 Interface, USB/RS-232 Dual Interface

Reading measurement results, remote control

Attention:
All terminals of the interface are galvanically connected
to the instrument chassis and hence also to the safety
ground (protective earth PE).
STOP
Elevated measurements, i.e. measurements where the input and output
terminals and hence also the instrument chassis are connected to a
high reference potential are not permitted and endanger operator,
instrument, interface and peripheral devices! In case these warnings
and the warnings given in the section „Safety" are disregarded, HAMEG
refuses any liability for personal injury and/or damage to HAMEG or
other equipment, possible damages will not be repaired under the
warranty

Description

The instrument features a RS-232 or combined USB/RS-232 interface
(option HO720), which is implemented with RS-232 as female 9-pin sub
D connector and with USB as socket contact type B on its back panel.
This bidirectional interface allows to remotely control the instrument
as well as the transmission of parameters and measurement results
to a PC.

USB cables

The double shielded cable must be
interface HO720 (option) the combined USB/RS-232 interface is re-
cognized automatically by the fi rmware of the spectrum analyzer. After
switching on the interface is indicated in the Readout by the reference
INTERFACE HO720.
6 7 9 8 10 12
17 16 14
18 15
30 31 29
< 3 m. After installation of the
Subject to change without notice
11
13
35