Intended Use; Scope Of Delivery; Initial Assembly - Mesto MAXIMA 3238 Mode D'emploi

GB IRL
Never use pressure sources other than
original MESTO
compressed air filling valves.
Doing so may cause the pump, the screw
cap or the valve to be hurled off causing
injury and the sprayer could also explode.
Avoid naked flames
combustible liquids.
Fire and explosion hazard!
Have damaged and/or inoperable parts
replaced immediately by our technical service
team or one of our authorised dealers.
Due to the risk of contamination:
- Wear suitable protective clothing when
spraying harmful substances.
- Do not spray into the wind.
- Do not spray substances at other persons,
animals or in open waters.
- Never aim hose ends at other persons or
yourself.
- Do not blow through any blocked nozzles or
valves in an attempt to clean them.
Never repair or alter the tank yourself.
Explosion hazard!

3.2. Intended Use

The device is intended exclusively for
spraying pesticides, including herbicides, in
the concentrations
substance manufacturer.
3.3. General Information
Substances, other than those indicated
above and the aforementioned excluded
applications constitute improper use.
We are not liable for any damages or injuries
resulting from improper use and for any user
changes to the sprayer.
Use of the sprayer for the intended purpose
also means that these Instructions for Use
have been read and observed!
These compression sprayers are not suitable
and may not, under any circumstances, be
used with:
- Very viscous, adhesive or residue-forming
liquids (dyes, greases) that cannot be fully
cleaned out of the sprayer.
- Do not leave the sprayer in the sun.
6893000
AUS
pumps or MESTO
when spraying
indicated by
USA NZ
- Do not leave the sprayer pressurised for
more than 1 hour. For safety, pull-up the
knob from the safety valve (Figure 15).
- While pumping, always observe the piston-
type pressure gauge and do not exceed the
permissible
Technical Data).
- Always operate and carry the sprayer in an
upright position.
- After use
activities, completely depressurise the tank.
Pull-up the knob from the safety valve until the
tank is depressurised (Fig. 15).

4 Scope of delivery

(Figure 1a or 1b)
Keep the Instructions for Use so you can
refer to them at a later date. Do not throw
away!

5 Initial Assembly

Assembly Instructions, see page 3.
6 Get ready for use
Always depressurise first. Pull-up the safety
• • • •
valve until air stops blowing (Figure 2).
Now remove the screw cap from the tank
• • • •
(Figure 3a) and place the cap into the
holding slot (Figure 3b).
the
The filter can either be left in the filling
• • • •
opening (Figure 4a) or placed inside the
cap (Figure 4b).
Fill the tank with the spray liquid. Observe
• • • •
max. filling level (5 l) (Figure 5). The filling
level can be read-off from the graduated
window (most conveniently from inside to
outside through the filling opening).
11
CDN
operating pressure
and prior to maintenance
(Figure 2-12)
IND
(see
0408