Irl Aus Usa; Scope Of Delivery; Instructions For Use; Cdn Ind - Mesto PRIMER 3237P Mode D'emploi

GB IRL
Do not allow the device to remain under pressure and/or exposed directly to
sunlight. Make certain the device is not heated beyond the maximum operating
temperature (→Table 1). Protect the device from frost.
Never blow through the nozzles or valves with your mouth.
Use only MESTO spare and accessory parts.
We cannot assume any liability resulting from the use of third-party parts.
Wear suitable protective equipment when working with hazardous substances.
When pumping, always observe the piston pressure gauge to ensure the maximum
spraying pressure is not exceeded (→ Table 1 below).
Before filling, after use and before maintenance work, allow the residual pressure in
the tank to dissipate completely (→ Section "After Use", Section 1).

Scope of delivery

Tank [1] with pump [2], hose [3] with discharge filter [6], shut-off valve [4], instructions for
use [5], carrying strap [7] and spray wand [8]. (Fig. 1)
You will find the illustrations referred to above in the front fold-out pages 3 – 5 of these

Instructions for Use.

Technical data
Type of device
Max. filling amount
Total contents
Max. spraying pressure
Max. operating temperature
Weight when empty
Material of tank
Spray wand
Where device is carried
Technical residual quantity
Max. volume flow
Recoil force
Table 1
Assembly
1. Fasten the carrying strap [6] on the tank [1] (Fig. 2)
2. Push the hose [3] with the discharge filter [6] into the tank and secure it with the cap nut
[9]. (Fig. 3)
3. Push the tube [3] into the shut-off valve [4] and secure it with the cap nut. (Fig. 3)
4. Screw the spray wand [8] onto the shut-off valve [4] (Fig. 3)
AUS USA
PRIMER 3237P
5 l (1.1 gal)
6.9 l (1.5 gal)
30 ° C (86 ° F)
1.5 kg (3.3 lb)
13
NZ CDN
PRIMER 3238P
8 l (1.8 gal)
10 l (2.2 gal)
3 bar (43.5 psi)
40 ° C (104 ° F)
3 kg (6.6 lb)
polyethylene
plastic 48 cm (18.9 in)
on the side
< 0.04 l (< 0.01 gal)
1.0 l/min (0.22 gal/min)
< 5 N
IND