Attaching Or Replacing The Grinding Disc; Starting And Ending The Treatment - Silk-n VACUPEDI NV8615D Mode D'emploi

6.1 Attaching or replacing the grinding disc

The product includes 3 grinding discs
and Coarse. With particularly rough skin, we recommend
you to start with the Coarse grinding disc.
1. Make sure the product is turned off.
2. Remove the cover
3. Remove the attached grinding disc from the product. If
necessary, use the handle of the cleaning brush
aid the removal (see step 1 in Fig. B).
4. Attach the desired grinding disc onto the spindle
(see step 2 in Fig. B).
You will hear a click sound when the grinding disc is
secured into place.

6.2 Starting and ending the treatment

1. Make sure your feet are clean and completely dry.
2. Press the control button ( )
The product is now turned on at a low speed. The LED
lights will light up blue.
8
3. Press the control button ( ) again if you want a higher
speed setting.
The product is now turned on at a high speed. The
LED lights will blink blue.
4. Move the rotating grinding disc
your skin you intend to treat. In the process, apply
gentle pressure and only keep the grinding disc on a
spot on your skin for two to three seconds at a time,
then check the result (see Fig. C).
Do not cover the ventilation holes
to avoid overheating.
The dust created during treatment will be sucked into
the dust chamber
5. When treatment is done, press the control button ( )
a third time to turn the product off. The LED lights will
also turn off.
if it is attached to the product.
3
1
4
.
10
: Fine, Medium
4
once.
over the parts of
during operation
9
EN
to
13
7
14