Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8.3.2
Logging on other DECT-GAP telephones to the base station
In order to log on a DECT-GAP handset, follow the instructions in the other supplier's operating manual and then
press the
button on the base station for 6 seconds. Use the PIN-Code 0 0 0 0 to log on.
8.3.3
Logging off handsets
A handset can only be logged off using another handset that is still logged-on. It is therefore not possible to carry out
the logging-off procedure using the handset that is to be logged off.
1.
Press the
button on the handset.
2.
Select the SETUP menu with
3.
Select the DEL HANDSET function with
4.
Now enter the PIN code of the base station (factory setting 0 0 0 0) and confirm with the
5.
Now select the number 1 or 2 of the handset to be logged off and confirm with the
abort the process by pressing the
hear a signal tone. The handset is now logged off and can no longer be used for external and internal calls.
8.4
Additional base stations
You can increase the range of the handsets by using several base stations. In order to make use of this effect, all
base stations must be connected to a telephone socket. Depending upon the application, you can allocate the same
telephone number to each base station or you can give the base stations different numbers. Make sure that the
ranges of all base stations overlap. Each handset must be logging on to each basis station. Please test the range of
the handsets before putting a new base station into operation.
If a handset is logged on to the base station and if the automatic base station selection is activated (further information
in this chapter), the handset is always forwarded automatically to the nearest base station. Current calls cannot be
transferred from one base station to another.
Selecting a base station
1.
Press the
button on the handset.
2.
Select the REGISTER menu with
3.
Select the SELECT BASE menu with
4.
The display will now show all base stations that the handset is already logged on to. The number of the
currently active base station will flash. Select the required base station to which the handset is to be switched
by means of the number pad.
Or change to the AUTO setting with the
automatically to the nearest base station when the connection to the current base station becomes too weak.
5.
Confirm with the
- Multiple handsets -
and
and confirm with
and
button. If the logging-off is successful, after a few seconds you will
and
and
and
button.
.
and confirm with
and confirm with
.
and confirm with
buttons. With this setting, the handset changes
.
button.
button. You can
.
81
Publicité
Chapitres
Table des Matières
