Connecting In Access Point Mode Or Wired Lan Mode - Epson EasyMP EMP-745 Guide De Mise En Route

Connecting in Access Point Mode or Wired LAN Mode

This section explains how to connect using either of the following two methods.
• Wireless LAN Access Point Mode
This method is used for connecting to a computer via a wireless LAN access
point that is connected to an existing network system.
• Wired LAN mode
This method is used for connecting to an existing network system using a wired
LAN card and network cable.
If you normally have the computer connected to a network system via an access
point or a wired LAN, then you can keep the existing computer LAN settings as
they are and only make the required network settings at the projector.
If you use one of these connection methods, you can send images from the
computer via the network so that they can be projected by the projector, and you can
also monitor the projector's status from the computer.
At computer
Install the EasyMP software
(included)
Make the network settings (wireless
LAN or wired LAN)
Start EMP NS Connection
Tip :
For details on the available wired LAN card, please visit the Web site
"http://www.epson.co.uk/".
p.14
For wireless LAN
access point mode
Insert the wireless
LAN card
Basic Wireless LAN
( Access Point Mode )
Settings
p.40
Start EasyMP (connection standby mode)
p.43
Carried out first
time only
At projector
For wired LAN
mode
Insert the wired
p.19
LAN card
Wired LAN
settings
p.34
Carried out second and
subsequent times
p.19
p.34
p.42
33