Technical Data - WAGNER W 690 FLEXIO EXTRA KIT Mode D'emploi

W 690 Flexio Extra Kit
Malfunction Cause
•
Too much fog of
•
coating material
(Overspray)
•
•
Paint in the
•
ventilating hose
•
Poor covering
capacity on the
wall
•
•

24. Technical Data

Max. viscosity:
Interior wall paint
Varnish paints, glazes, etc.
Max. flow rate:
Interior wall paint
Varnish paints, glazes, etc.
Power source
Power consumption
Double insulation
Sound pressure level*
Sound pressure output*
Oscillation level*
Air hose length
Weight
* Measured in accordance with EN 60745-1
Information about the oscillation level
The specified oscillation level has been measured according to a standard test
procedure and can be used to compare against electric tools.
The oscillation level is also for determining an initial assessment of the vibrational strain.
Attention! The vibration emission value can differ from the specified value when the
Distance to the object too large
Too much coating material applied
Amount of air too high
Diaphragm soiled
Diaphragm defective
Spray material is too cold
Highly absorbent surface or paint
with poor covering capacity
Distance too large
Technical Data
4000 mPas
60 DIN-s
400 ml/min
150 ml/min
~
230 V , 50 Hz
630 W
79 dB (A); Uncertainty K = 4 dB
92 dB (A); Uncertainty K =4 dB
< 2.5 m/s²; Uncertainty K = 1.5 m/s²
3.5 m
approx. 3.3 kg
GB
Remedy
➞ Reduce distance
➞ Reduce the material
volume
➞ Turn the air volume
control to the left (-)
➞ Clean the diaphragm
➞ Replace the diaphragm
➞ The material you are
spraying should be at
room temperature
➞ Cross spray (Fig. 16)
➞ Closer to the object
33