Configuration Of The Jbus Communication Parameters; User Interface - MGE UPS Systems SineWave JBUS Manuel D'installation Et D'utilisation

configuration of the JBUS communication parameters

user interface

Parameter lists:
A A A A A A ddress: address of the slave in the
JBUS network.
Rate: communication rate in bauds.
Parity and number of stop bits: even,
odd or no parity, 1 or 2 stop bits.
MGE UPS SYSTEMS
1 Choose the JBUS Communication
option with the up and down arrows.
MAIN MENU
Language
Main measurements
Secondary measurements
Alarms
Configuration
JBUS Communication
Identification
Access reserved
2 Validate the JBUS Communication
option by pressing ENT.
COMMUNICATION
Enter
the password:
3 Enter the password
(4 characters 1 1 1 1) then ENT.
COMMUNICATION MENU
Address xxx
Rate 9600 bauds
8 bits Even 1 stop
? Mem
4 Choose the parameters to be
modified with the up and down keys
and press ENT.
SineWave™ JBUS communication system installation: E-51027160XT/AC
F1 F2 F3
7 8 9
4 5 6 ESC
1 2 3 ENT
0 RUN STOP
For example modification of the
communication port rate.
RATE CHOICE
Rate: 1200 bauds
Rate: 2400 bauds
Rate: 4800 bauds
Rate: 9600 bauds
5 Choose the rate using the arrows
and validate with ENT.
COMMUNICATIONMENU
Address xxx
Rate 9600 bauds
8 bits Even 1 stop
? Mem
6 Press F2 to save the new
parameters.
SAVE
Confirmation: ENT
Abort: ESC
CAUTION:
SAVE = STOP SineWave
7 Press ENT again to confirm the
save.
SAVE
Saving in progress
This screen is displayed while the
parameters are being saved.
17