Venting Installation - Napoleon Vector Série Manuel D'installation

venting installation

EN
4. Roll the vent sleeve as shown and ensure to clip the ends together (Figure 4).
5. Ensure both ends line up and secure ends with clip and fasteners (Figure 5).
Fig. 4
Fig. 5
6. Insert the vent sleeve tabs into the fi restop spacer slots then bend the tabs over to secure to the fi restop
spacer along with 4 supplied fasteners (Figure 6).
Fig. 6
note:
Note orientation of dimples and standoffs.
30
W415-1709 / D / 06.14.19