Product Marking - Tractel dynafor LLX2 Instructions D'emploi Et D'entretien

Trouble
GB
Ineffective display

12 PRODUCT MARKING

All of the indicators and labels placed on the product by the manufacturer must be kept clearly readable.
Should they be lost or damaged, replace these indicators and labels before continuing to use the
appliance. Tractel
Dead sensor batteries
Sensor switched off or switched
to take standby mode.
Sensor too far from display unit.
Network conflict.
Sensor subject to compression
or torsion.
Negative imbalance of gauge
bridge.
Switch on a Master display unit
on a site where several LLXh
are already operating.
A connection has been made
using an USB lead between the
display unit and the PC without
having installed the Tractel
software.
Malfunction of the display.
can provide new labelling on request.
®
Marking sensor
Possible causes
®
36
Solutions
Replace batteries
Switch off display unit, switch on
sensor, switch on display unit.
Bring appliances closer together
Check network configuration
(advanced functions section
6.3.2.4).
Eliminate compression stress
on sensor.
Contact the after-sales service.
Select a other channel (see
§ 7.5.6).
Use the Tractel "PC Link"
®
option.
Keep the ON/OFF key pressed
during 10 sec.
Reboot both load cell and
display (see 6.1).
Marking
Marking battery
display
charger