Stopping The Device; Error Messages; Advanced Functions; Main Menu - Tractel dynafor LLX2 Instructions D'emploi Et D'entretien

6.2.4.7 Stopping the device

Display
11

6.2.5 Error Messages

No radio reception
12
GB

6.3 Advanced functions

This chapter presents the functions that enable advanced use of dynafor™ LLXh
See the general overview of the programme at the end of the manual.

6.3.1 MAIN Menu

13

6.3.1.1 Functions Menu

14
Action
No action
ESC
No action
Select an icon and enable the
available options
Select an icon and enable the
available options
Possible causes
Sensor switched off or switched to the
standby mode (see 27)
Sensor too far from display unit
Network conflict
High electrical magnetic interference
Confirm selection
Return to standard display
ESC
without modification
Select an icon and enable the
available options
Select an icon and enable the
available options
Confirm selection
Return to standard display
ESC
without modification
Select an icon and enable the
available options
Select an icon and enable the
available options
18
Comments
Stopping the device:
Keep the ON / OFF button
depressed for 3 seconds to switch
off the display unit.
The sensor automatically moves into
standby mode, and will start up
again when the display unit is
switched on.
If necessary you can switch off the
sensor by pressing on the ON / OFF
button.
Solutions
Switch off display unit, switch on
sensor, switch on display unit.
Bring appliances closer together
Check network configuration
(see advanced functions section
6.3.2.4).
Main Menu:
Select MENU.
Confirm with
Select the required sub-menu.
Confirm with
Functions Menu:
Select the required sub-menu.
Confirm with