Tractel dynafor LLX2 Instructions D'emploi Et D'entretien page 68

b) Adding a display unit operating on a different channel to the Master display unit.
50
51
GB
52
53
54
Confirm the selection
ESC
Return to previous window
Select an icon and enable the
available options
Select an icon and enable the
available options
No action
ESC
No action
No action
No action
Confirm the selection
General reset with no addition
ESC
of display
Select an icon and enable the
available options
Select an icon and enable the
available options
Confirm the selection
Return to the standard screen
ESC
with no additional display
Select an icon and enable the
available options
Select an icon and enable the
available options
No action
ESC
No action
No action
No action
32
Adding a display unit:
Go to the parameter setting menu
and select option
+
Confirm with
Scan environment:
The display unit scans all of the
channels other than its own and
identifies all the Slave units,
switched on, within an 80 m radius
(in open field).
Identification of the display units
present:
The first five Slave units that are
powered up, unlocked or disassociated,
present with a radius of 80 m are
displayed on the screen. If there are
more than five, select the "others" line
(or "start of list") and confirm to display
all the slaves present.
XXXXXXX = Serial No.
Selecting one of the display units
present:
Select the Slave display unit that will be
added to the Master display unit. The
display unit operating channel will be
automatically modified.
Confirm with
You can only add one display unit at a
time. Re-start the sequence for each
added display unit.
To finalise the procedure and use the
equipment in multiple configuration,
power down all equipment and then
power up again, starting with the
sensors and the Slave units and
finishing with the Master display unit.
Check the configuration using the icon
The example shows a configuration
where 4 sensors are associated with
4 display units.