Adding A Slave Display Unit - Tractel dynafor LLX2 Instructions D'emploi Et D'entretien

46
47
48

7.5.7.2 Adding a Slave display unit.

a) Adding Slave units operating on the same channel as the Master display unit.
Using the arrows, move to the icon
hereafter:
You can simultaneously associate sensors and Slave display units operating on the same channel, all
the components powered up appear in the "radio link" window
49
Confirm the selection
General reset with no addition
ESC
of sensor
Select an icon and enable the
available options
Select an icon and enable the
available options
No action
ESC
No action
Select an icon and enable the
available options
Select an icon and enable the
available options
No action
ESC
No action
No action
No action
, confirm using
Confirm the selection
ESC
Return to standard display
Select an icon and enable the
available options
Select an icon and enable the
available options
31
Selecting one of the sensors
present:
Select the sensor that will be added to
the multiple configuration. The
sensorʼs channel will be automatically
modified.
Confirm with
You can only add one sensor at a time.
Re-start the sequence for each added
sensor.
Re-start sensors + 1 in in X mode:
After you have confirmed your
selection, the messages "addition in
progress" followed by "completed"
are displayed.
Following this the unit re-boots.
All of the associated sensors are
displayed in the standard window.
Adding a sensor:
It is not possible to add a sensor if
the Sensor / Display unit assembly is
locked.
First of all unlock the assembly
before continuing, see section 7.5.1.
and follow the procedure described
Associate several components:
Once the general procedure has been
followed, the Slave units operating on
the same channel as the Master unit
are automatically associated.
= The sensor / display couple is
associated.
You can dissociate components:
= The sensor / display couple is
dissociated.
GB