Association Of Components; Adding One Or More Sensors - Tractel dynafor LLX2 Instructions D'emploi Et D'entretien

7.5.7 Association of components

7.5.7.1 Adding one or more sensors

a) Adding sensors operating on the same channel as the Master display unit.
Using the arrows, move to the icon
42
GB
b) Adding sensors operating on a different channel to the Master display unit.
43
44
45
, confirm and follow the procedure described hereafter:
Confirm the selection
ESC
Return to standard display
Select an icon and enable the
available options
Select an icon and enable the
available options
Confirm the selection
ESC
Return to previous window
Select an icon and enable the
available options
Select an icon and enable the
available options
No action
ESC
No action
No action
No action
Confirm the selection
General reset with no addition
ESC
of sensor
Select an icon and enable the
available options
Select an icon and enable the
available options
30
Associate several components:
Once the general procedure has been
followed, the sensors operating on the
same channel as the Master unit are
automatically associated.
= The sensor / display couple is
associated.
You can dissociate components:
= The sensor / display couple is
dissociated.
Adding sensors:
Go to the parameter setting menu
and select option
+
Confirm with
Scan environment:
The display unit scans all of the
channels other than its own and
identifies all the sensors, unlocked
or disassociated, within an 80 m
radius.
Identification of the sensors present:
The first five sensors that are powered up,
unlocked or disassociated, present with a
radius of 80 m are displayed on the
screen. If there are more than five, select
the "others" line (or "start of list") and
confirm to display all the sensors present.
XXXXXXX = Serial No.
2t / 0t5 = capacity
MM YY = calibration date