Turning On The Display Unit; Elementary Functions; Keypad Function Limitation - Tractel dynafor LLX2 Instructions D'emploi Et D'entretien

6.1.5 Turning on the display unit

Sensor
Identification
Metrological
check
Link locked
ON / OFF (3 sec)
The welcome screen is shown for 4 seconds, then the standard display window is shown.

6.2 Elementary functions

This chapter presents the functions that enable elementary use of dynafor

6.2.1 Keypad function limitation

This function is used to limit access to the advanced functions of the display unit.
In «Limited» mode, only the three basic functions are accessible: UNITS, TARE, MAX.
In «Full access» mode, all the functions are accessible.
Transition from one mode to another is achieved by a sequence of buttons on the front panel of the
display unit.
This function facilitates use of the LLX2 System by the operator while eliminating the risk of an
inadequate operation due to certain parameters being changed.
6.2.1.1 Deactivate «Limited» mode :
Press the ESC key when the display unit is switched off.
The next time the display unit is powered up, the MENU icon will appear in the upper left corner of the
screen in place of the icon representing a key.
6.2.1.2 Activate «Limited» mode:
Press the ESC key when the display unit is switched off.
The next time the display unit is powered up, an icon representing a key will appear in the upper left
corner of the screen in place of the MENU icon.
A
Current time
LIMITED mode
13
Current date
LLXh.
™
FULL ACCESS mode
Date of last
metrological
check
Radio
channel used
GB