Charge Pulse Min/Max Time (In Remote-Mode Only); Cycle Ok Parameters; Setpoint Warning/Alarm Min./Max. Output Current Peak - Simco-Ion Charge Master Micro IQ Easy Notice D'utilisation

Générateur haute tension cc

Les langues disponibles

6.5.5 Charge pulse min/max time (in Remote-mode only)

The "Charge pulse min time" parameter (Figure 11) ensures that the high voltage at the

generator's output is active for a minimum period of time (which can be set) once the "Remote

On" signal has been received. If the "Remote On" signal is longer than the set time for "Charge

pulse min time", the "Remote On" signal takes precedence. The high voltage will then follow the

"Remote On" signal. The default setting for the "Charge pulse min time" is 0.00 sec (=inactive).

The "Charge pulse max time" parameter is a "Warning" setting. If the high voltage at the

generator's output is active longer than the "Charge pulse max time" value set, a warning will

appear on the Manager IQ Easy's screen. The default setting for the "Charge pulse max time" is

0.00 sec (=inactive).

Cycle OK high delay (Figure 12), between the moment the CMM IQ Easy detects that the

cable(s) have been charged and activation of the "Cycle OK"-signal, an additional delay can be

set in order to increase process stability.

Cycle OK low level, the level where the CMM IQ Easy detects that the charge of the electrode

has decreased sufficiently can be adjusted for additional process optimisation.

With the "Setp warning min outp cur pk", "Setp warning max outp cur pk", "Setp alarm min outp

cur pk" and "Setp alarm max outp cur pk" parameters (Figure 13), warnings and alarms can be

set to monitor the minimum and maximum output current peaks. The default setting for these

parameters is 0,00 mA (=inactive)

Figure 13.

CMMEasyCMMIQEasy_UM_9752098500_NL_D_GB_F_V3_1

Table des Matières