Technical Specifications - Simco-Ion Charge Master Micro IQ Easy Notice D'utilisation

4 Technical specifications

Power supply and I/O
Supply voltage
Electricity consumption
Max. total cable length at
the power supply
Max. cable resistance per
wire
Standard Simco
5x 0.34mm² & M12 Male-
Female cable
Optional Simco cable
5x 0.75mm²
High-voltage setpoint
Remote On/Off input
Speed after Remote On
Cycle OK output
Connection
Output
Output voltage
Output current
Environment
Operating environment
Temperature
Protection class
Signalling
Cycle OK output
LED indications
Green flashing quickly
Green flashing slowly
Orange
Red
Red flashing slowly (1Hz)
Red flashing quickly (5Hz)
CMMEasyCMMIQEasy_UM_9752098500_NL_D_GB_F_V3_1
21–27 V DC
Max. 0.9 A
24V DC ±2%
28m
56m
4–20 mA output voltage control,
kV, 20 mA = 20 kV
Serial, using the Simco-Ion IQ platform (CMM IQ Easy only)
15 - 30 V DC = high voltage ON, 0 - 5 V = high voltage OFF
Serial, using the Simco-Ion IQ platform (CMM IQ Easy only)
Unloaded from 0 to 20 kV in 15ms
maximum 0.4 s (connected to the IQ Easy platform)
24 V DC (±3 V), 50 mA max.
Serial, using the Simco-Ion IQ platform (CMM IQ Easy only)
M12 connector, 5-pin
0–20 kV DC negative
Max. 0.4 mA
Industrial, internal use
0–55°C
IP54
24 V DC (±3 V), 50 mA max.
Serial, using the Simco-Ion IQ platform (CMM IQ Easy only)
Start up
Standby, HV output not active
Normal operation, HV output active
HV output overloaded, HV output active
1) Generator overheated, HV output temporarily inactive
2) Supply voltage too low, HV output unchanged
3) Cycle OK, HV output overloaded, HV output active
4) Output current peak too high or too low, HV
output unchanged (only CMM IQ Easy)
5) Charge pulse too long, HV output unchanged (only
CMM IQ Easy)
6) Eeprom reading error, HV output unchanged
No communication with the Simco IQ platform, HV output
inactive (only CMM IQ Easy)
24V DC ±5%
20m
40m
24V DC ±10%
6.5m
13m
50