Backrest Installation; Tools Necessary For Installation; Hardware Installation - Physipro Valeo Manuel D'utilisation

ENGLISH

5 Backrest Installation

5.1 Tools necessary for installation

5.2 Pre-Assembly
Use screw C and nuts D to assemble the backrest supports A and E with the backrest
cane holders B. At this stage, secure lightly, as the adjustment will be made later. The
5° adjustment angle assembly has to be installed on top of the backrest.
D

5.3 Hardware installation

Using screws J, washers I and nuts D, install the hardware system F and G on the back of
the backrest. At this stage, secure lightly, as the adjustment will be made later.
A
D
E
Figure 5
Tool Chart
C
J
M
N
O
C
B
Figure 4
H
D
6
Valeo Back
4 mm Allen Key
2x Flat-head screwdriver
4 mm and 10 mm
Allen Key
F
5° adjustment
angle assembly
Install on top of
the backrest
G
Pivot Hinge assembly
Install on the bottom
of the back
F
J
I
G