JUKI LK-1941 Manuel D'utilisation page 65

(4) Making the sewing pattern
Position of starting
sewwing
starting sewwing
2nd origin
1) Receding position of the feeding frame (application of the 2nd origin)
Therer is a case where the feeding frame is slanted and the material is hard to be set in accordance with
the material. In this case, it is easier to set the material if the 2nd origin is set to near-by the center of the
feeding frame.
100
4.5
Position of
Center of the feeding frame
Setting the cloth
Recess for intermediate
presser
4.5
Origin
Start
2) When using the feeding frame blank
In case where the lift of the feeding frame is high,
the feeding frame is likely to come in contact with
the intermediate presser. In this case, it is
recommended to set receding position of the
presser (2nd origin) described in item 1) and to
make a recess for the intermediate presser in the
feeding frame blank.
3) Position of the thread trimming
1) Do not enter the thread trimming data in the
slant section if possible. There may be a case
where the thread is not trimmed.
2) When entering the thread trimming control, set
the pitch of the last stitch to 2 mm or more.
The input device is necessary when
creating the sewing pattern.
End
53