JUKI LK-1941 Manuel D'utilisation page 19

(4) Changing the voltage
Changing the voltage between 100 and 240V
When the voltage of 100V or 200V is supplied, following voltages can be used by changing the terminal
board.
Line color (White)
Terminal board No.
1
1
1
1
1
1
Voltage change : 100V ←→ 200V
When voltage of 100V, 110V or 120V is used, it is necessary to connect the voltage
change cord (Part No. M90215800A0) to J32 connector mounted on the POWER
circuit board.
When voltage of 200V, 220V , 230V or 240V is used, do not install J32 connector.
If the setting of J32 connector is mistaken, the control box is likely to be broken.
Changing the voltage between 220V and 415V
When the voltage from 220V to 415V is supplied, following voltages can be used by changing the terminal
board.
Line color (White)
1
1
1
1
1
Line color (Blue)
2
3
4
5
6
7
Line color (Black)
Terminal board No.
2
2
2
2
2
Input voltage
100
110 With J32 connector
120
200
220 Without J32 connector
230/240
Line color (Blue)
4
5
6
7
8
Remarks
Input voltage
220
230/240
380
400
415
7