DVA AL5 Notice D'utilisation page 25

AL AL
instruction instruction
manual manual
PROBLEM
Water from the brine is not sucked
the water softener does not consume salt
(there will be a salt alarm)
The brine overfills:
- If the excessive filling occurs during
the regeneration
(there will be a salt alarm)
- If the excessive filling occurs when
the machine is operating
Water softener salt consumption
is higher or lower than expected
After regeneration, water is not softened
The water softener dispenses salt water:
- If it only happens once
- If it is a recurring problem
Instruction Manual AL CRONOMETER
CHRONOMETER CHRONOMETER
RESOLUTION
- make sure that the water system pressure is at least 2 bar
- check that the drain pipe is not blocked or flattened (fig. 5, A)
- clean the injector (fig. 10, B) (see paragraph 9.1)
- make sure that there is no air intake where there are the quick joints (fig. 12, A)
- make sure the drain pipe isn't blocked or flattened (fig. 5, A)
- make sure that there is no air intake where there are the quick joints (fig. 8, A)
- clean the injector (fig. 10, B) (see paragraph 9.1)
- check that operating pressure is at least 2 bar
- make sure the selected model is correct
- In case the refill time has been changed to include extra-rinse,make sure that
the duration of step B7 falls between the range values (see paragraph 5.5)
- make sure there are no leaks between upper part and tank (fig. 1, C and D)
- make sure water does not seep in the brine tank from the brine pipe (fig. 12, A)
make sure the selected model is correct (see paragraph 5.4). In case the
refill time has been changed to include extra-rinse,make sure that the dura-
tion of step B7 falls between the range values (see paragraph 5.5)
- Check salt presence in the brine tank, in case the salt alarm is not on (see
paragraphs 5.6 and 5.7.2).
- Check correct start of the mixing screw, in case the salt alarm is on. (ima-
ge 3, M) (see paragraph 8)
his problem may be caused by a lack of hydric pressure during the rege-
neration, thus preventi correct rinsing, Start the resin rinse program (see
paragraph 7.4)
Increase by some minutes the B5 time in the EXTRA-RINSE (see paragraph
5.5, TAB. 3)
ENGLISH ENGLISH
25