Water And Ice Dispensers; (On Some Models) - Jennair W11490758B Guide D'utilisation

GETTING STARTED
TURN POWER ON OR OFF:
1.
Remove the top grille panel.
2. Press Power switch to the ON or OFF
position.
3. Replace top grille.
IMPORTANT: Be sure the power switch is set to
the ON position after cleaning refrigerator or
changing light bulbs.
A. Power switch
14 | GETTING STARTED

WATER AND ICE DISPENSERS

(ON SOME MODELS)

IMPORTANT:
After connecting the refrigerator to a water
■
source or replacing the water filter, flush
the water system. Use a sturdy container to
depress and hold the water dispenser lever
for 5 seconds, then release it for 5 seconds.
Repeat until water begins to flow. Once
water begins to flow, continue depressing
and releasing the dispenser lever
(5 seconds on, 5 seconds off) until a total
of 3 gal. (12 L) has been dispensed. This
will flush air from the filter and water
dispensing system, and prepare the water
filter for use. Additional flushing may be
A
required in some households.
NOTE: As air is cleared from the system,
water may spurt out of the dispenser.
Allow 24 hours for the refrigerator to cool
■
down and chill water.
Allow 24 hours to produce the first batch
■
of ice. Discard the first three batches of ice
produced.
The dispensing system will not operate
■
when the freezer door is open.
Depending on your model, your water and
■
ice dispensers may have one or more of
the following features: a dispenser tray, a
special light that turns on when you use
the dispenser, or a lock option to avoid
unintentional dispensing.
WATER DISPENSER
To Dispense Water by Paddle:
1. Press a sturdy glass against the water
dispenser pad.
2. Remove the glass to stop dispensing.
NOTE: Water may have an off-flavor if you do
not use the dispenser periodically. Dispense
enough water every week to maintain a fresh
supply.
To Dispense Water by Control Panel:
NOTE: This function is able only if the Measured
Fill function is active.
Measured Fill allows you to dispense a specified
amount of water with the touch of a few
buttons.
1.
Put a sturdy glass under water spout. Touch
MEASURED FILL to activate.
NOTE: The amount of water you select will be
dispensed. Make sure the container can hold
the entire volume. If ice is in the container, you
may need to adjust your selection.
2. Touch MEASURED FILL to turn on, then
touch to select 8 oz (0.2 L), 16 oz (0.5 L), or
24 oz (0.7 L). Touch the fourth time to exit
Measured Fill display.
3. Touch DISPENSE WATER and the selected
amount of water will be dispensed.