Water Filter Status Indicator; Refrigerator Use; Power On/Off Switch - Jennair W11490758B Guide D'utilisation

GETTING STARTED

WATER FILTER STATUS INDICATOR

The water filter indicator, located on the control
panel, will help you know when to change the
water filter.
REPLACE STATUS:
Replace the water filter cartridge when
■
the water filter status display changes to
"Replace."
REPLACE OVERDUE STATUS:
When the light turns red on the control
■
panel, this tells you that it is time to change
the water filter cartridge.
It is recommended that you replace the
■
filter when the status light turns red or
water flow to your water dispenser or ice
maker decreases noticeably.
NOTE: If water flow to your water dispenser or
ice maker decreases noticeably, change the
filter sooner. The filter should be replaced at
least every 6 months, depending on your water
quality and usage.
When dispensing water after the Replace Filter
icon is on, the Replace Filter icon blinks
for the duration of dispensing. This applies for
both the Replace Filter starus and Replace
Overdue status. Fourteen days after the
Replace Filter indicator turns On, it shall enter
"Replace Overdue" mode.
FILTER RESET
After changing the filter, press and hold Filter
Reset button for 3 seconds. The button will no
longer display once reset.

REFRIGERATOR USE

If the supply cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similar qualified person. Do not use a
cord that shows cracks or abrasion damage
along its length or at either the plug or connec-
tion end.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result
in death, fire, or electrical shock.
WARNING
Explosion Hazard
Keep flammable materials and vapors, such
as gasoline, away from refrigerator.
Failure to do so can result in death,
explosion, or fire.

POWER ON/OFF SWITCH

If you need to turn the power to your
refrigerator On or Off, you must remove the top
grille assembly to access the power switch. Turn
the power to the refrigerator Off when cleaning
your refrigerator.
INTEGRATED INSTALLATION - FULL HEIGHT /
ARMOIRE MACHINE COMPARTMENT COVER
To install the grille panel to the refrigerator:
1. Slide the upper and lower slots in each
bracket onto the mounting pins extending
upward from the top of the refrigerator.
2. Push the grille panel forward to fully
engage the spring clips and fasten the
grille panel.
TO REMOVE THE GRILLE PANEL FROM THE
REFRIGERATOR:
1.
Open the door(s).
2. Place both hands under the grille panel,
grasping the bottom edge between your
fingers and thumbs.
3. Pull the grille panel straight out until the
grille stops. Then, lift up on the grille panel
to remove.
GETTING STARTED | 13