Jennair W11490758B Guide D'utilisation page 15

GETTING STARTED
NOTES:
The Measured Fill dispenser will
■
automatically time out after 1 minute of
inactivity.
You can refill several glasses with the same
■
measurement by continuing to touch
DISPENSE WATER after each glass fill.
NOTE: Water may have an off-flavor if you do
not use the dispenser periodically. Dispense
enough water every week to maintain a fresh
supply.
For crushed ice, cubes are crushed before
being dispensed. This may cause a slight delay
when dispensing crushed ice. Noise from the
ice crusher is normal, and pieces of ice may vary
in size. When changing from crushed to cubed,
a few ounces of crushed ice will be dispensed
along with the first cubes.
MEASURED FILL
Calibrate Measured Fill
Household water pressure may affect the
accuracy of the Measured Fill feature. For
optimum performance of your water dispenser,
you must first calibrate Measured Fill.
Start Calibration Mode
1.
Press and hold the Measured Fill button for
3 seconds to enter Calibration Mode. The
button will display along with the 0.2 L or
8oz default settings.
2. Pressing the water pad will dispense water
(e.g., into a measuring cup) until the desired
amount is dispensed. Releasing the water
pad will stop water dispensing.
Save and Exiting Calibration
1. 1. If water was dispensed, pressing the
Measured Fill button will save the amount
dispensed, a tone will play and the
calibration amount display will blink twice.
2. 2. If no water was dispensed, Pressing the
Measured Fill button will exit Calibration
mode without saving the calibration
amount.
NOTE: The amount of water you select will
be dispensed. Be sure that the container is
empty and can hold the entire volume. If ice is
in the container, you may need to adjust your
selection.
IMPORTANT: Low water pressure may affect the
accuracy of this feature.
1. 1. Press MEASURED FILL to turn the feature
on. When the feature is on, the Measured
Fill screen appears on the display.
2.
2 To dispense water, press a sturdy glass
against the water dispenser pad OR place
the glass below the water dispenser and
press the MEASURED FILL button. Hold the
glass close to the water dispenser spout to
ensure that the water dispenses into the
glass.
NOTE: The dispenser will automatically turn off
Measured Fill after 1 minute of inactivity. When
Measured Fill is turned off, any changes you
have made will be lost and all defaults will be
restored.
NOTES:
Most coffee cups (commonly 4 to 6 oz [118
■
to 177 mL] per cup) are not the same size
as a measuring cup (8 oz [237 mL]). You
may need to adjust the volume to avoid
unintentionally overfilling coffee cups. A.
Water dispenser spout A Units Default
Minimum Maximum Ounces 8 1 128 Cups 1
¹/₄ 16 Liters 0.25 0.05 4.0.
While dispensing water, the digital
■
display will count down how much water
remains to be dispensed, according to the
volume you selected. The flow of water will
automatically stop once the desired volume
has been dispensed.
To Dispense Ice:
1. Press the button to select the desired type
of ice.
WARNING
Cut Hazard
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
2. Press a sturdy glass against the ice
dispenser pad. Hold the glass close to the
dispenser opening so ice does not fall
outside of the glass.
IMPORTANT: You do not need to apply a lot
of pressure to the pad in order to activate
the ice dispenser. Pressing hard will not
make the ice dispense faster or in greater
quantities.
GETTING STARTED | 15