Cleaning/Maintenance; Cleaning & Maintenance - Grizzly AGS 720 Lion-Set Traduction De La Notice D'utilisation Originale

GB
with the supplied blade mounting
key (27):
The marking both on the blade
drive and the label side of the
cutting head (2) must match
(31).
3. Put on the grass shear blade
(25). The non-moving shear
plate (34) should be facing out.
The recesses (35) on the blades
are fitting on the pins (36) in the
housing of the device.
4. Put on the blade cover (12) and
slide it towards the blade until it
snaps into place.
Insert hedge trimmer blade
1. Place the movable knife plate
(37) of the shrub shear blade
(23):
There are two markers. One on
the blade plate and the other
on the non-moving shear plate
(38). These have to match.
2. Before inserting the shrub shear
blade place the knife drive (30)
with the supplied blade mounting
key (27):
The marking on the blade drive
must point towards the lower pin
(36).
3. Put on the shrub shear blade
(23). The non-moving shear
plate (38) should be facing out.
The recesses (39) on the blades
are fitting on the pins (36) in the
housing of the device.
4. Put on the blade cover (12) and
slide it towards the blade until it
snaps into place.
128

Cleaning/Maintenance

Leave any work not covered in
this manual to our Service Cen-
tre. Only use original parts.
There is a risk of injury!
Ensure that the safety key (
is removed before all tasks.
Wear gloves when handling the
blades! There is a risk of injury
from cuts!
Never use cleaning agents or sol-
vents, which can cause irreparable
damage to the unit. Chemicals can
attack the plastic components on
the unit.
Clean and service the unit regularly as fol-
lows. This guarantees a long life for your
unit:
• Check the covers and guards for dam-
age and correct position. If necessary,
replace.
• Keep the ventilation slits, motor hous-
ing and handles on the equipment
clean. To do this, use a damp cloth or
brush.
• Always keep the blade clean.
After using the equipment, it is im-
perative to:
- Clean the blade
(with an oily cloth);
- Oil the blade shaft
with an oil can or
spray.
6)