Use As A Grass Trimmer; Use As A Hedge Trimmer; Cleaning/Maintenance - Grizzly AGS 108 Lion Traduction De La Notice D'utilisation Originale

Set de ciseaux à herbes et buissons à batterie
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 37
GB

Use as a grass trimmer

Grass is best cut when dry and not
too long.
Adjusting the working angle
For a comfortable edge cut, the cutter head
(1) can be rotated by 90° to the right or left.
1. Operate the lever (3) and turn
the cutter head (1) into the de-
sired position.
2. Release the lever (3), the cutter
head locks into place.
In addition, the device has 3 inclination
positions for the handle setting
1. Operate the release button (9)
and tilt the handle (1) into the
desired position.
2. Let go of the release button (9)
so that the handle locks into
place.

Use as a hedge trimmer

Do not use the shrub cutter in
combination with the telescopic
shaft. There is a risk of cut
wounds.
Move the unit forward evenly.
The double-sided cutting heads en-
able cutting in both directions or by
swinging the unit from side to side.

Cleaning/Maintenance

Leave any work not covered in
this manual to our Service Cen-
tre. Only use original parts. There
is a risk of injury!
80
Ensure that the battery (
removed before carrying out any
work.
Never use cleaning agents or sol-
vents, which can cause irreparable
damage to the unit. Chemicals can
attack the plastic components on
the unit.
Wear gloves when handling the
blades (
of injury from cuts!
Clean and service the unit regularly as fol-
lows. This guarantees a long life for your
unit:
Check the covers and guards for dam-
age and correct position. If necessary,
replace.
Keep the ventilation slits, motor hous-
ing and handles on the equipment
clean. To do this, use a damp cloth or
brush.
Always keep the blade clean.
After using the equipment, it is im-
perative to:
- Clean the blade
(with an oily cloth);
- Oil the blade shaft
with an oil can or
spray.
Slight notches on the blades can be
evened out. For this, sand down the
blades with an oil stone. Only sharp
blades can cut properly.
Blunt, bent or damaged blades must
be changed.
We are not liable for damage caused by
the use of the unit if the original cause
was improper repair or the use of non-
original parts or through use other than
that designated in this manual.
7) is
10/13). There is a risk

Publicité

Table des Matières
loading

Table des Matières