Specifications; Safety Precautions - APA 16622 Manuel De L'opérateur

3. SPECIFICATIONS

Dimensions:
Weight:
Length of mains cable:
Length of charging cable: 1.00 m + 0.50 m adapter charging cable
Input:
Output:
Battery capacity:
Ambient temperature:

4. SAFETY PRECAUTIONS

• Keep children away and do not allow children to operate this device!
• Only use this product as intended!
• Do not manipulate or disassemble the device!
• For your own safety, only use accessories and spare parts that are stated in these instructions or that are recommen-
ded by the manufacturer!
• The warning triangle labels all instructions important to safety. Always follow these otherwise you could injure
yourself or damage the device.
• Do not smoke and do not ignite naked flames when working on the battery. There is a risk of explosion.
• Only connect the device to a power socket installed according to regulations. The voltage must correspond to the
specification on the type plate of the device.
• Do not trap the power cable and protect it from sharp edges, damp, heat or oil. The power cable of the unit cannot
be replaced. In the event that the cable is damaged, the unit must be disposed of.
• Do not operate the device or immediately pull the plug if it is damaged or you suspect it may be defective. In this
case, contact our technicians.
• Pull the plug when the device is not in use.
• Keep packaging materials, especially plastic and plastic bags, away from children. Risk of suffocation.
• Remove all plastic from the device before use.
• Place the mains cable in such a manner that it does not impede and that it cannot be unplugged accidentally.
• Disconnect the battery charger from the power supply after the charging process.
• Keep the charger in a place that cannot be accessed by children or unauthorised persons.
• Never operate the device in the vicinity of flammable materials or in an environment prone to explosion.
• Always wear suitable working clothes, protective gloves and goggles. Battery acid is corrosive! Immediately and
thoroughly wash off any splashed acid and consult a doctor, if necessary. If battery acid gets into the eyes, immedia-
tely rinse under running water for at least 10 minutes and consult a doctor.
• Do not cover the charger, this may lead to overheating and result in damages. Never set the charger up for operation
on a surface that is insulating (e.g. polystyrene). There is a risk of heat built up!
• If you wish to charge a vehicle battery in the installed state, first park the vehicle safely, put on the parking break and
switch off the ignition. Cut the battery off from the on-board network of your vehicle. To do this, consult the manual
for your vehicle, or ask your specialist workshop.
• This charger enables you to charge a battery without needing to disconnect it from the on-board network. If you
wish to make use of this option, make sure that your vehicle will not be damaged by this process. For this purpose,
read the manual of your vehicle or ask your specialist workshop.
• To remove the battery charger, first pull the plug out of the socket and observe the sequence for disconnection. This
prevents sparks from forming. Since charging generates a detonating gas, this is particularly important for the sake
of your safety.
• Only hold the power cable at the power plug when disconnecting from the power socket.
• Never expose the charger to the vicinity of fire, heat and extensive temperatures over +40°C.
• Store these instructions carefully and, if necessary, pass them on to other users.
205 x 115 x 60 [mm]
0.670 kg
1.50 m
220-240 V AC 50/60 Hz
6 V mode: 7.2 V, 5 A
12 V mode Motorbike: 14.6 V, 5 A
12 V mode Car: 14.6 V, 10 A
6 V: 1.2 – 120 Ah
12 V: 1.2 – 200 Ah
-5 °C to +40 °C
9