Problem Identification; Attachments On Request - Stiga MP2 504 Série Manuel D'utilisation

14. PROBLEM IDENTIFICATION

PROBLEM
1. The engine will not start
or will not keep running
2. The engine runs
irregularly, lacks power
when revved or cuts
out whilst working
3. If the engine loods
4. The cut grass is
not collected in the
grass catcher
5. Irregular grass cutting
6. Excessive noise and/or
vibration is experienced
whilst working
If problems persist after having performed the above operations, contact your dealer.

15. ATTACHMENTS ON REQUEST

15.1 "MULCHING" KIT
It chops the grass cuttings inely and leaves them
on the lawn, instead of collecting them in the grass
catcher (for compatible machines) (ig. 23).
PROBABLE CAUSE
Incorrect starting procedure.
No oil or fuel in the engine
Dirty spark plug or incorrect
distance between the electrodes
Air ilter clogged
Carburetion problems
The lawnmower's fuel tank was not
emptied at the end of the previous
season The loat may be blocked.
Air ilter clogged
Dirty spark plug or incorrect
distance between the electrodes
Carburetion problems
The manual starter handgrip has been
used repeatedly with the starter inserted.
The manual starter handgrip has
been used repeatedly with the
spark plug cap removed.
The cutting means has collided with a
foreign object and received a knock
The inside of the chassis is dirty
The cutting means is not in good condition
Damaged or loose parts.
The pin on the cutting means
has slipped out of its seat.
Cutting means ittings are loose or
the cutting means is damaged
Follow the instructions (see chapter 6.3)
Check the oil and petrol levels
Check the spark plug (Consult
the engine manual).
Clean and/or replace the ilter
(Consult the engine manual).
Contact the authorised service centre.
Consult the engine manual and contact
the authorised service centre.
Clean and/or replace the ilter
(Consult the engine manual).
Check the spark plug (Consult
the engine manual).
Contact the authorised service centre.
Check the engine manual.
Insert the spark plug cap and try to start
the engine. (Check the engine manual)
Turn of the engine and disconnect
the spark plug cap.
Inspect for damage and
Contact a Technical service centre
for the replacement of the cutting
means if necessary. (par. 8.1)
Clean the inside of the chassis to ease the grass
discharge towards the grass catcher (par. 7.3.1)
Contact a Technical service centre for the
sharpening or replacement of the cutting means
Stop the machine and disconnect
the spark plug cable (ig. 22).
Inspect for damage.
Check for and tighten any loose parts.
Have all checks, repair work and replacements
carried out by a specialized Centre only.
Turn of the engine and disconnect
the spark plug cap.
Contact an authorised Technical service centre
for checks, replacements or repairs (par. 8.1)
EN - 12
REMEDY