Smoke Extractor Calibration; Summer / Winter Mode; Menu 2. Keyboard Menu; Contrast - BOREAL HYDROBOREAL-14 Instructions D'installation, D'utilisation Et D'entretien

Smoke Ext. Calibration
P1
Max: 7
Set: 0
P2
Min: -7
P3
9.7.1.6.

SUMMER / WINTER MODE

This menu has two options: "Summer" and "Winter". In case we chose the winter
mode the boiler will be able to manage heating and sanitary water. Sanitary water
will have priority and should be installed directly to the boiler. In case we have
only one heating circuit the boiler will work same way but only with this circuit
parameters. The use of this working mode is recommended during the coolest
periods.
In case we chose the summer mode it will work when we install a system of
sanitary water because the boiler consider that in summer we do not need heating
the house, only sanitary water. If our installation do not have sanitary water we
recommend select the winter mode.
9.8.

MENU 2. KEYBOARD MENU

9.8.1.

CONTRAST

This menu allows to modify the contrast of the light in the display. It is selected with
the keys P4 and P6 in increasing or decreasing value respectively and confirm the
value with the key P3.
P1 Brightness Min.
P2
5
P3
9.8.3.

KEYBOARD ADDRESS

Menu protected by password (Not available for end user), and allows to adjust the
direction of the node RS485
FSYSR02000002.1.0 0
P1
MSTR 247
FSYSF03000098.0.0 0
P2
KEYB 16
P3
9.7.1.5.

SMOKE EXTRACTOR CALIBRATION

With keys P4 and P6 you can increase or decrease the fixed value . The fixed value
from factory is 0 and the range is between -7 to +7. Consider that each value you
P4
modify is equivalent to modify proportionally 5% each power the value of fan speed
(rpm) assigned to the smoke extractor. The selected value should be confirmed with
the key P3 before going out of the menu.
P5
Consider that as more smoke extractor speed the more smoke extraction we have
but also the more air inlet in the combustion chamber (larger flame). In case you see
P6
the boiler does not burn properly or the mix combustible/air is not the right one try
with this loading parameter.
P4
9.8.2.

MINIMUM BRIGHTNESS

P5
This feature allows you to choose the minimum brightness level to save power. The
P6
device is automatically set after 30 seconds of inactivity.
If 0 is selected, the screen will turn off completely after 30 seconds of inactivity.
P4
P5
9.8.4.

NODE LIST

P6
This menu shows the communication direction of the board, type of board and
firmware versions.
Summer-Winter
P1
Summer
P2
Winter
P3
Contrast
P1
P2
9
P3
PASSWORD?
P1
....
P2
P3
EN
P4
P5
P6
P4
P5
P6
P4
P5
P6
45