Menu 2. Thermostats; Boiler; Dhw; Menu 3. Chrono - BOREAL HYDROBOREAL-14 Instructions D'installation, D'utilisation Et D'entretien

9.6.2.

MENU 2. THERMOSTATS

This menu modifies the heating and DHW temperature of your boiler.
EN
9.6.2.1.

BOILER

This menu allows to select the water temperature in the boiler. You can select
between 40º and 80º C, that is to say the temperature you want your boiler to
reach.
The selected value should be confirmed with the key P3 before going out of the
menu.
When the water temperature of the boiler reaches the requested value by the
user, the boiler starts mode "stand by", i.e. starts modulation lowing the power to
adequate to the selected temperature of the water and keep on working. In this case
it is possible that your house do not reach the temperature requested from the external thermostat because the water temperature value that you have
fixed is low for your comfort temperature. We recommend putting an enough temperature value (70-75º) to allow the boiler keep on working and reach
your house comfort temperature.
9.6.2.2

DHW

This menu allows selecting the temperature in the puffer tank. In case you do not
want to use your boiler to produce sanitary water you should skip this menu. You
can select between 40º and 55º C, that is to say the temperature you want your
boiler to reach. The selected value should be confirmed with the key P3 before
going out of the menu.
9.6.3

MENU 3. CHRONO

IMPORTANT NOTE. Before proceed with your boiler programming
check the date and hour. Otherwise the programming will be set up
according to the fixed date and hour and could not satisfy your needs.
This menu allows the programming to automatically switch on/off your
boiler following the parameters you fixed daily, weekly or weekend.
In order to access the different programming possibilities of your boiler, you must
choose the chrono option and confirm with the P3 button and you will see the
following screen:
9.6.3.1.

SUBMENU 3.1. MODALITY

In this submenu, you can choose between enabling or disabling the programming
of the boiler and also choose between the other programming possibilities (daily,
weekly or weekend).
In order to select the desired programming, press the P3 key until one of the options
flashes (intermittent). With the keys P4 and P6 you can select the different options,
and you must confirm the selected option with the key P3.
To enable the selected programming, with the line flashing or blinking, press key P2 to change OFF to ON.
You can only choose 1 of the 3 options, so you cannot select two or more combinations.
To exit the menu, press the P1 key.
P1
P2
P3
9.6.3.2.

SUBMENU 3.2. PROGRAM

In order to modify the time slots of each programming, select the "program
submenu" and use the P4 and P6 keys to select the programming you wish to carry
out: daily, weekly or weekend.
42
OFF
Daily
Weekly
Weekend
P1
P2
P3
P1
P2
P3
P1
P2
P3
P4 P1
P5 P2
P6 P3
P1
P2
P3
Boiler
Max: 80
Set: 75
Min: 40
DHW
Max: 55
Set: 55
Min: 40
Modality
Program
ON
Daily
Weekly
Weekend
Daily
Weekly
Weekend
P4
P5
P6
P4
P5
P6
P4
P5
P6
P4
P5
P6
P4
P5
P6